Unigraf UCD-240 066415 Automated USB-C Test Tool features an efficient and effortless way of testing video, audio and interface signal continuity of USB‑C. UCD-240 test coverage includes DisplayPort Alt Mode, Power Delivery, USB 2.0 and USB 3.0 functionalities. UCD-240 also supports HDCP 1.3 and HDCP 2.2. UCD-240 comes with built-in test sets for automated CRC, Link and Electrical tests. The provided software enables user access to the vital test parameters and all tests can be easily run from the command-line. Further, Unigraf’s TSI or third party Test Management Software can be used as a platform to run any automated tests on UCD-240.
UCD-240 is a cost-effective and flexible test solution that can be used as a part of a bigger test automation solution or on a plug and play basis, the delivery content includes UCD-240 Hardware Device, Test Automation Software, Electrical Testing cables supporting automatic CC line flip, regular USB-C cable and USB 3.0 flash drive with pre-stored sequence files and Software installation package. UCD-240 Test Tool comes with built-in automated test sequences for video, audio, link and electrical tests.
USB-C DisplayPort Alternate Mode support
Built-in test sequences for USB-C test automation
Electrical Test to verify whole USB-C connector with single cable insert
Test USB 2.0 and USB 3.0 functionalities
4K @60 Hz Support
Easily configure ready-made tests in UCD Console GUI
Run tests from command-line
Third-party Test Management Software support e.g. NI TestStand support
Unigraf’s TSI Support
Single External Power unit will be needed with UCD-240 Tester
Two External Power unit will be needed with UCD-240 Dual Tester