Teradek Beam 10-0571

  • Product Code: 10-0571
  • Availability: In Stock
  • $7,595.00

Available Options




The Teradek Beam 10-0571 is a full HD camera-back H.264 encoder, capable of delivering stunning video at bit rates up to 50Mbps.* Beam utilizes the unlicensed 5GHz band and can transmit video up to 2500ft with just 2 frames of latency. Whether the job requires a wireless link back to the OB Van or an MPEG-TS stream back to the station, Beam gives broadcasters unparalleled flexibility in the field.

This set comes with 1 Beam Rx with 3G-SDI Output and includes a dedicated bidirectional IFB channel. Beam is multicast capable to an unlimited number of Rx over LAN and to up to 4 receivers over WiFi. Please view the individual Beam section below to order more Beam receivers. The Beam Tx has 3G-SDI Input, is a full HD camera-back H.264 encoder, capable of delivering stunning video at bit rates up to 50Mbps* using unlicensed 5GHz band with a range of 2500ft with just 2 frames of latency.

*Transmitting above 30Mbps requires using the LAN port.
 
Features:
 
Up to 2500ft range over WiFi!
Low Latency 70ms - 80ms!
Transmits to up to 4 receivers over WiFi
High bit-rate broadcasts - up to 30Mbps over WiFi, 50Mbps over LAN
OLED Display for easy setup and status monitoring
Rugged Enclosure, transmitter mounts to any AB or V-mount camera
Supported inputs and resolutions: 480i 59.94/60, 576i50, 720p50, 720p 59.94/60, 1080PsF 23.98/24, 1080p 23.98/24, 1080p25, 1080p30, 1080i50, 1080i 59.94/60, 1080p50, 1080p 59.94/60
Blu-Ray quality video over any IP network, Utilizing H.264
Multicast capable over 10/100 Ethernet
3 x MIMO Access Point
Full IFB support with microphone input and headphone output
Looping HD-SDI output on transmitter
Bidirectional Serial Data pass-through
MPEG-TS included!
Transceiver sets ship in sturdy Pelican cases
 
Specifications:
 
Video Compression H.264 Baseline Profile Level 4.2 with de-interlacing
System Latency 90 - 110 millisecond delay between Transmitter and Receiver
Wireless range 2500ft +- 200ft
Digital Video In/Out SD-SDI, HD-SDI, 3G-SDI
Video Port TX: SDI input and looped Output, RX: SDI output
Supported Video Resolutions SMPTE244 480i59.94 (NTSC), 480i60 (861-D)
IEC61179-5 576i50 (PAL)
SMPTE 296M 720p23.98, 720p24, 720p25, 720p29.97, 720p30, 720p50, 720p59.94, 720p60
SMPTE 274M 1080i50, 1080i59.94, 1080i60, 1080PsF23.98,1080PsF24, 1080PsF25, 1080PsF29.97, 1080PsF30, 1080p23.98, 1080p24, 1080p25, 1080p29.97, 1080p30, 1080p50, 1080p59.94, 1080p60
SDI Compliance SMPTE 259M BI.656 SDTV Digital Signal/Data Serial Digital Interface
SMPTE 292M BT.1120 1.5Gb/s Signal/Data Serial Digital Interface
SMPTE 425M (option) 3Gbis Signal/Data Serial Digital Interface
SMPTE 299M 16bit Digital Audio Format for SMPTE 292M
SMPTE 352M Video Payload Identification for Digital Interfaces
Bitrate RTSP Server Up to 30Mbps
MPEG2-TS Server Up to 15Mbps
Main Digital Audio In/Out TX/RX SDI embedded audio: 48kHz 16-bit stereo linear PCM
Main Analog Audio Out RX 48kHz 16-bit stereo linear PCM with mini stereo phone output jack
Talk-Back Analog Audio In/Out RX/TX 8kHz 16-bit stereo linear PCM with mini stereo phone input/output jack
Radio Power Aggregate Power: 150mW (22dBm), 50mW (17dBm)/antenna
Radio standard IEEE 802.11a/n: OFDM
Frequencies U-NII-1 (5.15-5.25 GHz), U-NII-3 (5.725-5.85 GHz)
Antenna 3T x 3R MIMO, 3 antennas per WiMi6200TW/W1Mi6200RW
Security 802.1x, 802,11i, WPA2, WPA and WEP 64/128 TKIP 128bit AES
WPS Wireless Protected Setup for easy set up and security configuration
Ethernet LAN 10/100 BASE-TX, RJ-45 jack
Multicast WiFi: Up to 4 Receivers
LAN: No limit on number of receivers
External Control Full duplex RS422 serial port
USB Factory reset, IP configuration or firmware upgrade without PC
Power Input/Consumption DC 7V-17V, 12 Watt
Dimensions (H x W x D) (mm) 170 x 105 x 28 each board assembly (TX or RX)
Weight (g) TX: 990g
RX: 610g
Operating Temperature 0 deg C to 50 deg C
 
Includes:
 
1 Beam Tx
1 AB-Mount or V-Mount Battery Plate
1 Beam Rx
1 Teradek Protective Case